Sheet Metal Vertical Support Replacement - GMC 1986 P-Truck Service Manual

4. Air intake snorkel.
5. Upper radiator mount to sheet metal cross panel
bolts.
6. Upper radiator mounts.
7. Sheet metal cross panel to fender bolts (114).
8. Sheet metal cross panel to the hood latch bracket
bolts (91).
9. Sheet metal cross panel to radiator support baffle
panel bolts.
10. Sheet metal cross panel to the headlamp bezel
support bolts.
11. Sheet metal cross panel from the vehicle.
+«- Install or Connect (Figure 21)
1. Sheet metal cross panel to the vehicle.
2. Sheet metal cross panel to the headlamp bezel
support bolts.
• Assemble loosely.
3. Sheet metal cross panel to the radiator support
baffle panel bolts.
• Assemble loosely.
4. Sheet metal cross panel to the hood latch bracket
bolts (91).
• Assemble loosely.
5. Sheet metal cross panel to the fender bolts (114).
Tighten
• Bolts in steps 2 through 5 to 27 N m (20 ft.
lbs.).
6. Upper radiator mounts.
7. Upper radiator mount to sheet metal cross panel
bolts.
8. Air intake snorkel.
9. Primary hood latch. Refer to " Primary Hood
Latch Replacement."
10. Grille. Refer to " Grille Repalcement."
11. Headlamp bezels.
• Lower the hood.
SHEET METAL VERTICAL
SUPPORT REPLACEMENT
Remove or Disconnect (Figure 22)
1. Grille. Refer to " Grille Replacement."
2. Vertical support to sill bolts (17).
3. Front end panel to vertical support bolts (120).
4. Sheet metal cross panel to vertical support bolts
(115).
5. Vertical support from the vehicle.
SHEET METAL 2C-19
Figure 22—Front End Sheet Metal
Vertical Support
Install or Connect (Figure 22)
1. Vertical support to the vehicle.
2. Sheet metal cross panel to vertical support bolts
(115).
Tighten
• Bolts to 27 N m (20 ft. lbs.).
3. Front end panel to vertical support bolts (120).
Tighten
• Bolts to 18 N m (13 ft. lbs.).
4. Vertical support to sill bolts (117).