GMC 1986 P-Truck Service Manual page 320

3C-34 FRONT SUSPENSION
Install or Connect (Figures 32, 33, and 35)
NOTICE: For steps 1, 2, and 3, refer to the
"Notice" on page 3C#7 of this section.
1. Stabilizer link (116) to the front axle (157) (figure
35).
• Slide a retainer (117) and an insulator (118)
on to the link and insert the link into the
proper hole in the front axle.
• Insulator (118), retainer (117) and nut (136).
&
Tighten
• Nut (136) until the distance between each
retainer (117) is 2.08 cm (0.82 inches) (figure
35).
2. Stabilizer bar (166) to the frame (figure 35).
• Insulators (167) onto the stabilizer bar (166).
118 \
^ 1 1 8 1
A.
11 i j
114.
115.
116.
117.
118.
136.
Figure 35—Stabilizer Bar Attachm ents
166. Stabilizer Bar
167. Insulator
168. Clamp
169. Bo*!
170. Nut
171. Washer
Clamps (168), clamp bolts (169), washers
(171), and nuts (170).
Tighten
• Nuts (170) to 28 N m (21 ft. lbs.).
3. Stabilizer bar (166) to the stabilizer link (116).
* Washer (114) and nut (115).
Tighten
Nuts (115) to 68 N m (50 ft. lbs.).
4. Wheel and tire assembly. Lower the vehicle to the
ground.
B-07491