Graphic Symbols - GMC 1986 P-Truck Service Manual

OA-6 GENERAL INFORMATION
2
1
1. Engine I.D.
2. D istributor Pad
3. Engine I.D. (Optional Location)
7. Engine I.D.
8. Engine Case Pad
4. Clamp one end of the second cable to the
negative (-) terminal of the good (charged) battery
and make the final connection to a heavy metal
bracket (such as the mounting bracket for the
generator or air conditioner compressor if so
equipped) on the engine about 450 millimeters
(18 inches) from the discharged battery. Make
sure the cables are not on or near pulleys, fans,
Make Connections in Numerical Order
Do N O T Allow
Vehicles to Touchl
Battery in Vehicle
w ith Charged Battery I
Figure 8—Jump Starting Connections
L6 ENGINE
V
4 ^ /
V6 ENGINE
Figure 7—Engine I.D. Number Location
First Jum per Cable
Discharged
Battery
Second Jum per Cable
Make Last
Connection on
Engine or Frame,
Away from Battery
TD
A-9816
Dtional Location)
4. Engine I.D. {0[
5. Engine Case F
6. Engine I.D.
l3d
Jgj
•
V8 E N G I N E ^ A ^ ^ ^ ^
V8 ENGINES-DIESEL
or other parts that will move when the engine is
started.
5. Start the engine of the vehicle with the good
(charged) battery and run the engine at a
moderate speed for several minutes. Then, start
the engine of the vehicle that has the discharged
battery.
6. Remove the booster cables by reversing the
above installation sequence exactly. While
removing each clamp, take care it does not touch
any other metal while the other end remains
attached.

GRAPHIC SYMBOLS

Graphic symbols are used on some controls and
displays on the vehicle (figure 9). Many of these
symbols are used internationally.
F-00527