D) Disks; E) Tv Output; F) Osd Text; G) Tcp/Ip Settings - Sentry LE Series Manual

LE/LE-HC Series DVR User Manual
V1.4

d) Disks

Allows the addition and Setup of up to 16 Network File Server (NFS) hard disks. Select a disk
number from the screen and use the right arrow button to bring up the setup screen. Enter the IP
address and volume of the HDD. Use Test to ensure the disk is accessible and Save to save the
settings.

e) TV Output

Allows the definition of both a VGA monitor and TV (Composite video/S-video) display.
Please note that EITHER a VGA monitor or TV/composite
video monitor is supported at any one time. Displays can
be switched from VGA to TV by pressing the "TV" button
and switched back again by holding down the TV button.
Device Use right arrow button to change from
VGA to TV
Standard Choose NTSC for N. America
Output to Choose between Composite and S-Video
Delay (Sec) Sets the dwell time for camera switching (activated using the switching button
on the controller)
Camera (From) Sets the cameras to be switched
Camera (To)
Screen Split Allows selection of the number of camera window displayed
Time Stamp Allows choice of whether a time stamp will be displayed/recorded on each
camera's video and where this will be displayed on the camera image.
Time Format Allows choice of date format
Deinterlace Set On/Off. Deinterlacing will provide a superior image for moving objects.

f) OSD Text

Allows On Screen Display (OSD) of user defined text to be displayed and position defined using X,
Y coordinates

g) TCP/IP Settings

TCP/IP Settings are covered in Section 3.
Use the number pad on the remote
control to enter the numbers. Remember
that the numbers are not configured in a
traditional keyboard pattern so double-
check the entries. Press OK to save.
Figure 5.8
Figure 5.9
- 26 -
October 2006