K) Motion Detection; L) Set Pre-Alarm - Sentry LE Series Manual

LE/LE-HC Series DVR User Manual
V1.4 October 2006
the schedule setup section to configure start time and stop time (make both 00:00:00 for the full
day) and then pick the days of the week this is to be effective. Make sure to turn the "Enable" pull
down menu to "Yes" or the schedule will not run.
Use "Stream Video Setup" to indicate if the camera should record using motion detection, full time
or not have it turned on at all.
For the frame rate, in most instances, auto speed should be turned on. This will give the best
frame rate. However, each camera can be set to record between 1 and 30 frames per second but
total frames added up together cannot be higher than the LE/LE-HC Series DVR is capable of
recording.
k) Set Motion Detection
When motion detection recording is selected in
Section 4.3.0 the specifics of motion detection
are configured in this section. Select the video
source (camera). The camera image will show
on the left hand side of the screen as in Figure
4.15. Use the left mouse button to click on
squares to set detection area and use the right
mouse button to clear areas. Hold down the
left or right mouse button and drag to block
areas larger than single squares. Motion will
only be detected in areas that have the Set
Detection squares, marked in red.
Figure 4.15

l) Set Pre-Alarm

Use the "Set Pre-Alarm" to set the number of frames recorded before an alarm condition exists.
Each camera can be configured separately and be configured differently.
- 17 -