Opening Garage Door (Up Limit) - Genie 1035 Operation & Maintenance Manual

Programming Information

Opening Garage Door (Up Limit)

NOTE:
Beginning with garage door closed is recommended but not necessary.
READ AND UNDERSTAND STEPS 6-9 BEFORE PROCEEDING
6. Press and hold the UP arrow button (+) for two seconds
or until the long LED comes on blue. (The round LED
stays o .)
7. Release UP arrow button (+) and the round LED will
begin ashing blue. (the long LED will go o ).
8. Press and hold the up arrow button (+) to begin opening
the garage door. When the garage door is fully opened,
release the up button (+). If it has gone too far press
and release the down button (–) to move the door down
slightly. The door can be moved up or down with the
arrow buttons. Stop the carriage short of the opener
powerhead. It is important for the red cord to be clear of
the powerhead to allow for manual door operation.
9. Press and release the program/set button—both LEDs
ash blue and then go o .
The UP (OPEN) TRAVEL LIMIT IS NOW PROGRAMMED.
Steady Blue
Flashing
Blue
Flashing Blue
7