Programming Vehicle Remotes; Programming Homelink System; Programming Car2U System - Genie 1035 Operation & Maintenance Manual

Programming Vehicle Remotes

Programming HomeLink® System
Step 1 Clear HomeLink
Clear HomeLink by pressing and
holding down the rst and third buttons
until the indicator on the HomeLink blinks
slow and then fast for 20 seconds; then
release both buttons.
NOTE: Clearing the HomeLink will remove all previously
programmed garage door openers.
Step 2 Train HomeLink to the Genie Remote
Choose the button on the HomeLink that will be used to open the door.
NOTE: Hold the Genie Remote two inches from the HomeLink button.
Hold down the Genie remote button. While holding, press and hold the
chosen HomeLink button.
Hold down both buttons until the indicator on the HomeLink blinks slow
then fast. Once it blinks, release both buttons.
Step 3 Program HomeLink to the Genie Opener
A. Press and hold the PROGRAM button on the opener until the round
blue LED is ON. Release the button. The long purple LED will begin
ashing.
BLINKING
PURPLE
B. Press the chosen HomeLink button for two seconds and release. Press
that same button again for two seconds and release. The long LED
will ash blue and then turn o .
C. Press the HomeLink button a few more times until door moves.
NOTE: For additional instructions, see the motor vehicle manual,
www.homelink.com or visit www.GenieCompany.com
12
Programming Car2U ® System
Step 1 Clear Car2U to default settings
The default setting for the Car2U system is:
• Button 1 = Genie® Manufactured Openers
• Button 2 = LiftMaster® Manufactured Openers
• Button 3 = Wayne Dalton® Manufactured Openers
A. Press and hold buttons 1 and 3 for 20 seconds or until all three LEDs
begin to ash.
B. Release both buttons. The Car2U system is now set to the Factory
Default settings
NOTE: Clearing the Car2U remote will remove all previously programmed
garage door openers.
Step 2 Program Car2U to the Genie Opener
A. Press and hold the PROGRAM button on the opener until the round
blue LED is ON—release the button. The long purple LED will begin
ashing.
BLINKING
PURPLE
B. Press the designated Genie Car2U button for two seconds and release.
Press that same button again for two seconds and release. The long LED
will ash blue and then turn o .
C. Press the Car2U button a few times more until door moves.
Step 3 Changing Factory Default Button for a Genie Opener
A. Press and hold buttons 1 & 3 for ONE SECOND and release—all three
LEDs will light solid red.
B. Press and hold the button (2 or 3) to change it to Genie—the
corresponding LED will ash. While continuing to hold that button,
press and release button 1. Press and release button 1 again.
C. Release the button being held in step B and wait for the LED to stop
ashing. This button is now set for Genie. Repeat Step 2 for second
Genie Opener.
NOTE: For additional instructions see the motor vehicle manual,
learcar2u.com or visit www.GenieCompany.com