Figure 4-27. Removal of Front Shutter Housing
DUMP
PROBE
e. Using a square drive, remove the screw that secures Solenoid # 2 to the Lens Mounting Plate.
Gently lift off Solenoid # 2 being careful not to catch on the locating pin of the Far Focus Lens.
f. Using a solder aid tool, gently pry open the locking tabs that secures the front Lens to the Lens
Mounting Plate. Remove the Front Lens.
h. Using a narrow blade flat screwdriver, gently release the locking tabs (Figure 4-30) that secures
the PC Board and Lens Mounting Plate to the Base Block Assembly.
i. Once the locking tabs are released, turn over the Assembly (approximately 180
Base Block Assembly faces down. Gently lift off the PC Board and Lens Mounting Assembly.
Figure 4-28. Discharging Strobe Capacitor
4 - 23
BASE BLOCK
ASSEMBLY
FRONT SHUTTER
HOUSING
STROBE
CAPACITOR
CONTACTS
0
) so that the