Main Frame (Non-Gear Side); Disassembly - Polaroid Joshua Vision Service Manual

Main Frame (Non-Gear Side)

1. Disassembly (Figure 4-41)
a. Using a square drive, remove the screw that secures the Switch Retainer to the Main Body of
the camera.
b. Using a narrow blade flat screwdriver, gently pry out both ends of the Switch Retainer to
release it from the plastic locking tabs of the Erect Switch. Lift out the Switch Retainer.
c. Using needlenose pliers or tweezes, remove the Power Actuator Spring. Lift out the Power
Actuator Assembly.
d. Remove the Erect Sensor Spring and Door Latch Sensor.
e. Using a square drive, remove the screw that secures the Erect Switch to the Main Body of the
camera.
f. Using a narrow blade flat screwdriver, gently pry up the Erect Switch to release it from the
Main body of the camera. Lift off the Erect Switch.
g. Remove the Erect Sensor.
h. Using a narrow blade flat screwdriver, gently pry out the Flex Plug Switch Block to release it
from the Drive Cover on the Main Frame - Gear Side. Lift off the Flex Plug Switch Block.
i. Using a narrow blade flat screwdriver, gently pry up and push out to release each Battery
Contact from the Main Body of the Camera. Lift off each Battery Contact.
j. Remove the Overcenter Spring from its tab connection on the Main body of the camera.
k. Unwrap or peel off the Interconnecting Flex from the Flex Plug to its Motor Connections.
l. Gently pull up and out to disconnect the Interconnecting Flex from its Motor Connections.
m. Using a square drive, remove the screw that secures the Door Stop to the Main Body of
the camera. Lift off the Door Stop.
4 - 31