Table of Contents
Advertisement
The flames should look like those in Figure 18. To
clean the burner, use a soft brush after the burner has
cooled completely. Never use a vacuum cleaner on the
burner. It is recommended that the fire pit be stored
indoors during the winter if it will be subjected to freezing
temperatures. The LP cylinder must be disconnected and
removed from the appliance before the appliance can be
stored indoors.
Always purchase the correct size and grade of battery most suitable for the intended use. Replace all
batteries of a set at the same time. Clean the battery contacts and also those of the device prior to battery
installation. Ensure batteries are installed correctly with regard to polarity (+ and -). Remove batteries
from equipment which is not to be used for an extended period of time. Remove used batteries promptly.
PROBLEM
Burner won't light
Burner won't stay
lit after lighting
MAINTENANCE
TROUBLESHOOTING GUIDE
CAUSE
No Propane Gas at Burner
No Spark at Electrode
Lack of oxygen
Thermocouple not in flame
Thermocouple connection
at the main control valve is
loose
No Lava Rocks on Burner
REMEDY
Check that gas tank valve is open. Turn
control knob to "ON" and push control knob
in. Make sure tank has propane gas.
Check that AAA battery is installed with
negative (-) end first and has a charge.
Check that the wire is connected to the
ignition module. Check that the electrode is
not cracked or broken.
Remove excess lava rocks or fire ices from
around the ignition well.
Check that the tip of the thermocouple is
even with the top of the ignition well.
Remove any lava rocks from the igntion
well.
Tighten the thermocouple nut at the back of
the valve.
Cover the burner with lava rocks per the
instructions
14
Figure 18
Hide quick links:
Advertisement
Table of Contents
