Table of Contents
Advertisement
INSTALLATION
1.Identify parts packed in carton against the parts list. Remove all protective materials and
set parts on a flat, non-abrasive surface.
2. Attach the back panel to side panels by using four 1/4"x40 mm bolts and washers as
shown in Figure 2.Guide bolts through holes in back panel, into pre-drilled holes in the
side panels. Hand tighten only.
Figure 2
3. Attach the middle support to side panels by using four 1/4"x15 mm bolts and washers
as shown in Figure 3.Guide bolts through holes in middle support, into pre-drilled holes in
the side panels. Hand tighten only.
Figure 3
4. Attach the bottom connector to the right side panel by using a 1/4"x15 mm bolt and
washer as shown in Figure 4.Guide bolt through hole in bottom connector, into the
pre-drilled holes in the right side panel. Do not over tighten.
7
Hide quick links:
Advertisement
Table of Contents
