Table of Contents
Advertisement
BATTERIES
Make sure the control knob is in the "OFF" position. Unscrew
the push button cap on the ignition module located on the
control panel to access the battery compartment. The ignition
module requires one Alkaline AAA size battery (1.5V). The
negative (-) end goes in first. See Figure 16. Dispose of battery
safely. May explode or leak if charged or disposed of in fire.
Make sure of the polarity. Mercury and cadmium free.
Figure 16
LIGHTING INSTRUCTIONS
Warning: If these instructions are not followed exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
1. Make sure the control knob is in the "OFF" position. See Figure 17 Open the tank
valve all the way.
IGNITER BUTTON
Figure 17
CONTROL KNOB
2. Push in the igniter button. You will hear a slight clicking sound. With the igniter button
pushed in, push and turn the control knob to the "ON" position. the fire should light within a
few seconds. Once the flame is lit, release the igniter button and continue to hold the
control knob in for 10 to 15 seconds. Release the control knob. The control knob should
pop back out and then remain lit.
Note: If the fire does not light, turn the knob to the "OFF" position and wait five (5) minutes
before trying again.
3. To turn down the flame, push the control knob in slightly and turn to Medium (medium
or Low (small flame).
4. To shut down the fire pit, turn the control knob to the "OFF" position and turn off the tank
valve.
13
Hide quick links:
Advertisement
Table of Contents
