Adjustment - Sanyo VCC-HD4000P Service Manual

3. ELECTRICAL ADJUSTMENT
3-1. Table for Servicing Tools
Ref. No. Name
J-1
Pattern box
J-2
Calibrationsoftware
J-3
Chroma meter
J-4
Spare lump
J-5
Collimator
J-6
Spare lump (collimator)
J-7
Siemens star chart
J-8
USB "A" to "A" cable
Download the calibration software and the firmware
from the following URL.
http://www.digital-sanyo.com/overseas/service/
Place the DscCalDi.exe file, camapi32.dll file and
QrCodeInfo.dll file together into a folder of your
choice.
The version of calibration software should use 1.61b
or subsequent ones.
J-1
J-4
3-2. Equipment
1. PC (IBM® -compatible PC, Pentium processor, Window
2000 or XP)
2. Frequency counter
3.Monitor TV
3-3. Adjustment Items and Order
1. Timer Quartz Adjustment
2. Lens Adjustment (Infinity)
3. Lens Adjustment (1m)
4. Privacy Masking Adjustment
5. AWB Adjustment
6. CCD White Point Defect Detect Adjustment
7. CCD Black Point And White Point Defect Detect Adjust-
ment In Lighted
Part code
Number
1 VJ8-0190
1
VJ8-0192
1
1 VJ8-0191
1 VJ8-0260
1 VJ8-0282
1
1
J-3
J-8
Note: If the lens, CCD and board and changing the part, it is
necessary to adjust again. Item 1-7 adjustments should be
carried out in sequence.
3-4. Setup
1. System requirements
Windows 2000 or XP
IBM®-compatible PC with pentium processor
USB port
40 MB RAM
Hard disk drive with at least 15 MB available
VGA or SVGA monitor with at least 256-color display
2. Pattern box
Turn on the switch and wait for 30 minutes for aging to take
place before using Color Pure. It is used after adjusting the
chroma meter (VJ8-0192) adjust color temperature to 3100 ±
20 K and luminosity to 900 ± 20 cd/m
the lump and its circumference are high temperature during
use and after power off for a while.
3. Computer screen during adjustment
Calibration Upload
AWB
Firmware
Focus
QrCode
UV Matrix
Cal Mode
Initialize
OK
EVF VCO
Cal Data
LCD Type
OK
USB storage
Get VID Set
PID
Set
Backrush pulse :
Get
3-5 Connecting the camera to the computer
Chang the camera for the device mode according to the
procedure as follows when connecting it with "COM-
PUTER" and adjusting, and inspecting it.
1. It becomes a device mode if it turns on power while
pushing a top and bottom of the operation paner key at
the same time.
2. Confirm that LED of the front panel blinks.
3. Device mode of the camera is carried out and it connects
with a personal computer by the USB cable.
Device mode is reset when turning off power.
- -
8
2
. Be careful of handling
LCD
R Bright
B Bright VCOMDC
RGB Offset Gain VCOMPP
Tint Phase
H AFC Test
Setting
Language
Serial
Set
Video Mode
Set Rev.
Set
Factory Code
Set