Table of Contents
Advertisement
SETTINGS
White balance adjustment 6
Normally the switch 6 (WB) is set to the down (ATW: auto white
balance) position and the white balance is adjusted automatically. If a
manual white balance adjustment is necessary, follow the steps below.
Set the switch 6 (WB) to the up (M: manual) position, then adjust the
colour.
• Turn RED (VR302) to set the red ratio and/or BLUE (VR303) to set
the blue ratio.
VR302
6
RED
Synchronization settings
The default setting is internal synchronization (INT). You can
change the power supply synchronization by moving switch 7
to the up (LL) position. Refer to "Line phase adjustment"
for details.
VR303
BLUE
Line phase adjustment 7
When using a camera switcher to connect 2 cameras or more to one
monitor, there may be a vertical roll of the images when switched. In
such a case, set as described below.
1
Set the switch 7 (SYNC) to the up (LL) position.
2
Switch the display on the monitor from camera 1 to camera 2.
Adjust the LINE PHASE volume on camera 2 until the vertical roll
of the image stops.
If more than two cameras are used, please repeat this procedure
for all the cameras.
CAUTION:
If the vertical roll cannot be corrected by setting the LINE PHASE
volume on camera 2, try setting the LINE PHASE volume on camera
1. If it still cannot be corrected, please check that the polarity of the
power cords of all connected devices is correct.
7
12
English
Advertisement
Table of Contents
