Fisher & Paykel OB30 Series User Manual page 39

Changing the oven light bulbs
The oven is illuminated by three 12 volt/20 watt halogen bulbs. These have a very long life, but if
you should need to replace one, use only a replacement bulb purchased from your nearest Fisher
& Paykel dealer and follow these steps:
Allow the oven to cool and then turn it off at the wall.
1
Take out the shelves and side racks (see 'Removing and replacing the sliding shelves and side
2
racks') and use a small flat-head screwdriver to twist and lift the retainer clip at the top of the
glass light cover while holding the glass to prevent it falling. The clip pivots counter-clockwise
(see the diagram).
Carefully lift the glass cover out of the lower support and pull out the faulty bulb.
3
Holding the replacement bulb in a soft cloth or tissue (touching the bulb will reduce its life
4
span), insert the new bulb.
Reposition the glass cover and twist the top clip back in place. The procedure is the same for the
5
light in the roof of the oven cavity.
Note: oven bulb replacement is not covered by your warranty.
Sockets for
Retainer clip
the pins
Care and cleaning
Plate glass cover
Pins
Replacement bulb
37