Installing The Battery Charger - AT&T MDW 9000 Installation Manual

Installing the Battery Charger

If you are wall mounting the battery charger, follow Steps 1
through 9
If you are desk mounting the battery charger, follow only
Steps 1, 4, 5, and 9
Check to make sure the battery
1
charger's power cord is
unplugged from the wall outlet before
continuing. If you are desk mounting,
skip to Step 4.
To wall mount, gently place the
2
battery charger upside down.
Push in the wide end of the mounting
base (1) and lift upwards (2) to
separate the base from the battery
charger.
Reverse the mounting base (so
3
the wide end of the mounting
base is above the narrow end of the
battery charger). Insert the tab on the
narrow end of the mounting base into
the slot on the wide end of the
battery charger. Insert the tab on
the wide end of the mounting base
into the slot on the narrow end of the
battery charger, pushing the mount-
ing base down and slightly inward
until the tabs lock into place.
28
Wall Mounting Only
Wall Mounting Only