Positioning The Battery Charger - AT&T MDW 9000 Installation Manual

Positioning the Battery Charger

The battery charger can be placed on a desk, or it can be mounted
on a wall. Before you install the battery charger, note the following
considerations:
Locate the battery charger within 5 feet (1.6 m) of either side of
(and for wall or shelf mounting, within 5 feet (1.6 m) above) a
properly grounded 3-prong electrical outlet that is not controlled
by an on/off switch.
If your communications system uses an uninterruptible power
supply, such as a backup generator, be sure to connect the
battery charger to that power supply.
Do not locate the battery charger where it will be exposed to
direct sunlight or water.
WARNING:
The Rechargeable battery contains nickel and cadmium. Do
not burn or puncture the battery. Like other batteries of this
type, if it is burned or punctured, it could release toxic
material which could cause injury. Do not dispose of it in
household garbage. For information about recycling or
proper disposal, consult your local solid waste (garbage)
collection or disposal organization.
Go to "Installing the Battery Charger"
27