Printer Status - Argox G Series User Manual

Printer Status

LCD Display
PAUSE
MEDIA OUT
RIBBON OUT
SERIAL IO
ERROR
CUTTER FAILED READY
MEMORY FULL READY
HEAD OPEN
P. SENSOR O.R. READY
Blinking
LED
READY Printer is paused. Press PAUSE or
CANCEL to return to normal operation
mode.
MEDIA Media is uninstalled or used up. Load new
media to the printer.
READY
RIBBON Ribbon is uninstalled or end-of-ribbon
occurred. Load new ribbon to the printer.
READY
If you print in direct thermal mode, printing
without ribbon, set bit 1 of DIP Switch to
"OFF" position.
Format or baud rate of RS232
READY
communication is inconsistent between
printer and host.
Cutter cannot cut off the media, check
media and cutter.
Printer buffer full due to loaded soft fonts,
graphics or forms. Check data format. Call
for service.
Print head latch is not closed. To make
READY
printer print labels normally, the head latch
must be closed.
Media sensor is out of detection range
during calibration. Make sure media is
installed and the label sensor locates under
media properly.
55
Description