Advertisement
Shurflo 9300 Solar Water Pump Installation Instructions
Install the supplied connector pipe to the
pump. You will need a 3/8 to 1/2"
adapter to connect to your output pipe.
Unroll enough pipe to equal the depth of
the pump. Lay it out on the ground
leading away from the well head. Then
lay out the power cable, rope, water
level sensors if you are using them.
For suspending the pump, use a
polypropylene rope. Nylon stretches,
which can cause stress on the electric
cable. Secure the rope to the pump with
a good knot.
Band rope, cables, and pipe together
with zip ties or black tape or every five
or six feet.
Before making your first band, put a little
slack in the cables and pipe near the
pump. That way the weight of the pump
will be on the rope, not the cables or the
pipe.
Then you are ready to lower your
Shurflo 9300 Solar Water Pump into the
well. Be careful not to abrade the water
level sensor wires on the lip of the well
head. Keep a firm grip on the rope/cable
so you don't lose the pump down the
well. Tie the far end of the rope onto
something if you need to. Keep the rope
out of the sun or it will deteriorate.
Page 5
Advertisement
