Advertisement
Shurflo 9300 Solar Water Pump Installation Instructions
Wrap the end of the cable with 6 inches of
black tape. This s to help the Inner Cable
Boot and Outer Cable Boot slide over the
cable.
Your Shurflo 9300 comes with rubber sleeves
(Cable Boots) that will prevent water from
getting into the electric connection area. Put a
good coat of silicone grease (supplled with
the pump) on the cable and slide the Cable
Nut, Outer Cable Boot, and Inner Cable Boot
over the taped area and onto the cable. The
Cable Boots can stretch and break, so be
careful.
Remove the tape, cut each wire about 3/4"
long, and cut off 1/2" of insulation, leaving
about 1/4" of insulation.
Page 2
Advertisement
