Advertisement
Shurflo 9300 Solar Water Pump Installation Instructions
Slide the wires into the plug. Notice the
divider between the wires. There shouldn't be
any copper showing above the divider. To
insert the wires, you may need to back out
the small allen screws a little with a 5/64"
allen wrench. You don't have to worry about
polarity, the Shurflo 9300 will run fine either
way. Then tighten the screws securely. Some
people use silicone glue around the
connection, but it's not necessary if you use
the right cable and follow the preceding steps.
Slide the Inner Cable Boot until it snaps onto
the first step on the plug.
Wipe off the grease from the cable and wrap
a six inch piece of black tape around the end
of the cable. This is to help the Outer Cable
Boot slide over the Inner Cable Boot.
Page 3
Advertisement
