PhaseOne H 25 Getting Started page 14

H 25 Getting Started
It is possible to use "Ultra Low Power" mode on
Mechanical cameras, but precautions must be taken not to
trigger too fast and "Mirror Up" is not supported when
using this setting.
To ensure capture reliability, we recomend that you look at
the green LEDs on the back of the camera back while you
slowly press the mechanical trigger on the camera body.
You can safely press the button all the way in the moment
the LEDs flashes.
Hasselblad 503 CW with Winder CW
If operating in mirror up mode, the mirror up mode has to
be set in the Capture One software. This is done on a Mac
by pressing command + M or on a PC by pressing CTRL + M
on the keyboard.
Please note that the Phase One H 25 should not be
mounted while the camera is set to mirror up.
Also make sure that the lens is not jammed or locked open
on the "B" setting when connecting the flash sync cable to
the Phase One H 25.
Power Condition:
If you are using a 503 CW winder you could set the Camera
power mode to "Normal."
1 2