Hasselblad 555 Eld - PhaseOne H 25 Getting Started

H 25 Getting Started
Hasselblad 553 ELX
Avoid using A or AS mode.
Please note that the Phase One H 25 should not be
mounted while the camera is set to mirror up (S or RS
modes). Also make sure that the lens is not jammed or
locked open on the "B" setting when connecting the flash
sync cable to the Phase One H 25.
Power Condition:
If you are using the Hasselblad 553 ELX you should set the
Camera power mode to "Normal."
It is possible to use Ultra Low Power mode on this camera
when using a motor cable and only using the capture
button inside the Capture One Application.

Hasselblad 555 ELD

When using the Phase One H 25 with a Hasselblad 555
ELD, the shutter release on the front of the Hasselblad
must be in the "Digital" position. If using the shutter
release is in the "Film" position you must make sure that
the Camera power mode is set to "Normal" in the Capture
One application.
A motor cable is not required when using the camera on an
Hasselblad 555 ELD body.
1 0