Trouble Shooting - µ-Dimension Glow DSP8 Instruction Manual

Trouble Shooting

DSP8 does not turn on
No sound from DSP8
My DSP8 doesn't sound
like my settings on the
user utility.
My computer wont
connect to the DSP8
My computer says USB
not connected when
doing firmware update-
Profile 1 wire does not
change settings-
Profile 2 wire not
working-
My ears are Hurting and
things aren't sounding
-Check and verify main fuse, ground
connection and remote turn on lead.
-Verify mixer is set correctly. -Un mute
all channels. -Verify DSP8 is seeing
speaker connection in the Class D tab
of the user utility. -Power DSP8 Off
and On
-Go to the EQ panel and press
"Sync>DSP8" so the PC and DSP8
are matched in settings
-Disconnect all unnecessary USB
devices. -Update your PC's USB
drivers and operating system. -Make
sure you have Microsoft .Net installed
on your computer. -Be sure to turn on
the DSP8 first, then connect the USB
cable followed by starting the user
software (See Page 11)
-Make sure you have manually
installed your USB boot loader driver
to your PC. (See Page 20)
-Make sure that this wire see's
switched and held 12v+ to change to
the alternate profile setting.
-This wire currently has no function.
- Chances are you are a music lover
and have been in the vehicle for an
extended length of time tuning. Take
a break and give your ears a rest.
Page 47