Headlamp Flasher - SMART FORTWO Owner's Manual

Driver's seat occupied or
g
driver's seat and front-
passenger seat occupied
Other loading
1
Settings are not required
2, 3 and
4
X
Turn the ignition key to position 2 in the
ignition lock or start the engine.
X
Turn headlamp range control : to the
position which corresponds to the load
in your vehicle.
Switching on the turn signals
X
Start the engine.
X
To indicate briefly: press the combina-
tion switch briefly to the pressure point
in the direction of arrow : (right turn
signal) or ; (left turn signal).
The corresponding turn signal flashes
three times.
X
To indicate: press the combination
switch beyond the pressure point in the
Exterior lighting
direction of arrow : (right turn signal)
or ; (left turn signal).
Switching on the main-beam headlamps
and headlamp flasher
Main-beam headlamps
X
To switch on: start the engine.
X
Turn the combination switch control
until K or à (if available) is at
the marking.
X
Press the combination switch beyond the
pressure point in the direction of
arrow :.
The K indicator lamp in the instru-
ment cluster lights up.
X
To deactivate: move combination
switch : back to its normal position.
The K indicator lamp in the instru-
ment cluster goes out.

Headlamp flasher

X
To switch on: pull the combination
switch in the direction of arrow ;.
89
Z