Loading Rolls In The Printer - Canon IPF850 User Manual

iPF850
5
Insert the Holder Stopper from the left in the Roll Holder as
shown. Holding it at the position shown (b), push it firmly in
until the flange (a) of the Holder Stopper touches the roll.
Lock the Holder Stopper lever (c) by pushing it down to-
ward the shaft side.

Loading Rolls in the Printer

Loading Rolls in the Printer

Follow these steps to load rolls in the printer.
You can load rolls in two positions, in the Roll 1 (Upper) and Roll 2 (Lower) holders.
If the Stacker is installed on the printer, first remove the Stacker from the printer. (See "Installing and Removing the
Stacker On the Printer.")
•
Always load rolls when the printer is on. If the printer is off when you load a roll, the paper may not be advanced
correctly when you turn the printer on.
Important
•
Before loading a roll, confirm whether the inside of the Top Cover or the Ejection Guide is soiled. If soiled, we
recommend cleaning in advance. (See "Cleaning Inside the Top Cover.")
Loading rolls in the Roll 1 (Upper) holder
1
Press the Load button.
2
Press ▲ or ▼ to select Roll 1 (Upper), and then press the OK button.
•
If any cut sheet has been fed, or roll paper that will not be used has been fed from Roll 1 (Upper), a
message is shown requesting you to remove it.
Note
Press ▲ or ▼ to select Yes, and then press the OK button. Remove the paper and go to the next step.
•
If roll paper is loaded in Roll 1 (Upper) but Roll 1 (Upper) is not selected as the paper source, a message
asking you whether or not to change paper is displayed.
Press ▲ or ▼ to select Load, and then press the OK button. Remove the paper and proceed to the next
step.
User's Guide
P.376
➔
Loading Rolls in the Printer
b
a
P.599
➔
345