In The Box; Location Of Inline Pressure Boosting System - Franklin Electric Inline 400 Owner's Manual

Inline Pressure Boosting System

In the Box

A. Inline Pressure Boosting System
B. Installation Manual
All Franklin Electric Inline Pressure Boosting Systems are carefully tested, inspected, and
packaged to ensure their arrival in perfect condition. When the unit is received, examine it
closely to make sure there is no damage that may have occurred in shipping.
If damage is evident, report this immediately to your shipping carrier and product dealer.
The shipping carrier assumes full responsibility for the shipment's safe arrival. Any claim for
damage to the shipment, either visible or concealed, must be made through the shipping
carrier first.
Status Display
Solid Green
Indicates system is powered and is turned ON, but not currently
running. The green solid light will only be present when no
faults are active.
Flashing Green
Indicates the pump is powered, turned ON, and running.
Solid Red
Indicates the control is powered but currently in the OFF mode.
Pressing the button will toggle the unit into the ON mode.
Flashing Red
Indicates a FAULT has occurred. The unit will automatically attempt to restart. If an
immediate restart is needed, the button can be pressed to force a reset if the fault is no
longer present. If the problem persists, a qualified water professional should be contacted.
Button
The button can be used to turn the unit on or off. When the unit is powered but in the OFF
mode (solid red light), a press of the button will turn the unit ON. If the unit is powered and in
the ON mode (solid green light), a press of the button will shut the unit OFF. The button can
also be used to force a reset after a fault.

Location of Inline Pressure Boosting System

Decide on a location for the pump installation that is suitable based on the enclosure
rating of the Inline Pressure Boosting System. Choose a clean, well-ventilated location
that provides protection from freezing, flooding, and excessive heat. In addition, it should
provide access for servicing and allow convenient draining of the pump housing, tank, and
service pipes. A prepared foundation is not essential, provided the surface is hard and level.
s
NOTICE
!
6
The Inline Pressure Boosting System is designed for indoor use only.