Franklin Electric Inline 400 Owner's Manual page 2

Pressure boosting
Hide thumbs Also See for Inline 400:
Table of Contents

Advertisement

Available languages

Available languages

Before Getting Started
Read and follow safety instructions. Refer to product data plate(s) for additional operating
instructions and specifications.
This is the safety alert symbol. When you see this
one of the following signal words and be alert to the potential for personal injury:
s
WARNING
DANGER
!
property damage if ignored.
s
WARNING
!
major property damage if ignored.
s
CAUTION
!
property damage if ignored.
s
WARNING
NOTICE
!
Carefully read and follow all safety instructions in this manual and on pump.
s
WARNING
!
RISK OF ELECTRIC SHOCK - This pump is supplied with a grounding conductor and grounding type
attachment plug. To reduce risk of electric shock, be certain that it is connected only to a properly
grounded, grounding-type receptacle. Disconnect power before working on or around the Inline
system. Do not use the Inline system in swimming areas.
This equipment should be installed by technically qualified personnel. Failure to install it in compliance
with national and local electrical codes and within Franklin Electric recommendations may result in
electrical shock or fire hazard, unsatisfactory performance, or equipment failure. Installation information
is available through pump manufacturers and distributors, or directly from Franklin Electric at our toll-
free number 1-800-348-2420.
This equipment must not be used by children or persons with reduced physical, sensory or mental
abilities, or lacking in experience and expertise, unless supervised or instructed. Children may not use
the equipment, nor may they play with the equipment or in the immediate vicinity.
If the power cord is damaged, it must only be replaced by qualified personnel.
s
CAUTION
!
• Keep work area clean, well-lit, and uncluttered.
• Keep safety labels clean and in good condition.
• Wear safety glasses while installing or performing maintenance on pump.
• Do not run pump dry. Fill pump with water before starting or pump will be damaged.
• Make sure all ELECTRICAL POWER IS OFF before connecting any electrical wires. Wire Inline
Pressure Boosting System for correct voltage. Follow all pump wiring instructions provided in the
"Wiring" section of this manual.
warns about hazards that will cause serious personal injury, death or major
warns about hazards that can cause serious personal injury, death or
warns about hazards that will or can cause minor personal injury or major
indicates special instructions which are imported but not related to hazards.
s
WARNING
!
symbol on your pump or in this manual, look for

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents