Table of Contents
Advertisement
PAINT
TI3502A
TI3503A
FLUSH
18
309859
FLUSH
Note: If flushing with water, flush again with mineral spirits or Pump Armor, but do
not repeat step 8 or 14. This leaves a protective coating in the system to
help prevent freezing or corrosion.
14. Raise siphon tube above flushing fluid and run
sprayer for 15 to 30 seconds to drain fluid. Turn
power OFF.
15. Install filter bowl and filter assembly. Hand tighten
filter bowl. Install filter assembly into gun. Hand
tighten gun handle.
16. Wipe sprayer, hose and gun with a rag soaked in
water or mineral spirits.
17. Clean tip, guard and gasket with a soft bristle
brush. Assemble parts and attach loosely onto
gun.
Advertisement
Table of Contents
