Carrier 40MB*C Installation Instructions Manual page 9

Cassette ductless split system system sizes 09"" 18 air conditioner
Hide thumbs Also See for 40MB*C:
Table of Contents

Advertisement

1.3
Install the indoor unit
When installing optional accessories,
read the installation
manual for the optional accessories.
Depending on the field
conditions,
it may be easier to install optional accessories
before
the indoor unit is installed (except for the decoration
panel).
However, for existing ceiling, install the fresh air inlet component
kit
and branch duct before installing
the unit.
1)
Install
the indoor
unit temporarily.
- Attach the hanger bracket to the suspension
bolt. Be sure to
fix it securely by using a nut and washer from the upper and
lower sides of the hanger bracket.
Secure the hanger bracket see figure below.
2)
1
2
I
Nut (field supply)
2
Washer (field supply)
3
Hangerbracket
4
Double nuts (field supply,tighten)
Fix the paper pattern for installation.
(For new ceilings
only)
- The paper pattern for installation
corresponds
with the
measurements
of the ceiling opening. Consult the builder for
details.
The centre of the ceiling opening is indicated on the paper
pattern for installation.
After removing the packaging
material from the paper patten for
installation,
attach the paper pattern for installation
to the unit
with the attached screws as shown in figure below.
4)
S)
Check if the unit is horizontally
_eveHed.
Do not install the unit tilted. The indoor unit is equipped with a
built-in drain pump and float switch. (If the unit is tilted against
the direction
of the condensate
flow (the drain piping side is
raised), the float switch may malfunction
and cause water to
drip.)
Check if the unit is levelled at all four corners with a water level
or a water-filled
vinyl tube as shown in figure below.
I
2
1
2
Water level
Vinyl tube
Remove the paper pattern
for installation.
(For new ceiling
only).
3)
I
Paper patternfor installation(onsome models)
2
Center of the ceiling openiing
3
Screws(suppliedwith the decoration panel)
Adjust
the unit to the right position
for installation.
(Refer to the chapter "Preparations
before installation"
on page 5.)
9

Advertisement

Table of Contents
loading

Table of Contents