Monte Carlo Fan Company 5LLR56 Owner's Manual And Installation Manual page 6

17
Blue (For Light)
White (For Light)
Red (Motor 1)
Purple (Motor 2)
Gray (Motor 3)
Receiver
White (AC IN N)
Make wiring connections using wire connectors provided as indicated above.
Red from fan to Red from remote marked Motor 1.
Purple from fan to Purple from remote marked Motor 2.
Gray from fan to Gray from remote marked Motor 3.
Blue from fan to Blue from remote marked FOR LIGHT.
White from fan to White from remote marked FOR LIGHT.
White (Neutral) from house to White from remote marked AC IN N.
Black (Live) from house to Black from remote marked AC IN L.
Connect all green grounded wires to Grounded wire from House.
Make sure that no filaments are outside of the wire connectors.
Insert the remote receiver into mounting bracket.
19
Raise canopy to mounting bracket,
aligning loosened screws in mounting
bracket with slotted holes in canopy.
Twist canopy to lock. Reinstall the screws
removed in step 18 and tighten all
screws securely.
© 2014 Monte Carlo Fan Company
Wall Switch
Green/Ground
Black (AC IN L)
20
Top plate
Blade bracket
Align the holes of blade bracket, blade
and the top plate of blade bracket.
Install blade bracket with blade by 4
blade screws provided. Tighten screws
securely. Repeat this process for
remaining blades.
Install the blade assembly to motor using
the set screws provided. Tighten screws
securely
Repeat this process for remaining blade
assemblies.
Black (Live)
Power source
White (Neutral)
Blade assembly
Blade
6
18
Partially loosen 2 of the set screws on
mounting bracket corresponding to the
slotted holes on the canopy upper ring.
Remove the other 2 set screws. Save
screws.
21
Loosen 2 and remove 1 preassembled
set screws from the plate on motor. Save
screw for later use.
10/1/2014