Monte Carlo Fan Company 5LLR56 Owner's Manual And Installation Manual page 3

1
Before you begin installing the fan, Switch
power off at Service panel and lock
service disconnecting means to prevent
power from being switched on
accidentally. When the service
disconnecting means cannot be locked,
securely fasten a warning device, such
as a tag, to the service panel.
Use AC 120V/60HZ power supply
only.
Downrod Mount Installation
4
Downrod
Remove preassembled keeper pin and
cross pin from downrod.
© 2014 Monte Carlo Fan Company
2
Before installing this fan make sure the
outlet box is properly installed to the
house structure. To reduce the risk of
fire, electric shock, or personal injury,
mount to outlet box or supporting system
acceptable for fan support.
(Mounting must support at least 35 lbs.)
5
Downrod
Canopy
Keeper pin Yoke cover
Cross pin
Place downrod over canopy and yoke
cover
3
Use metal outlet box suitable for fan
support and use only the screws provided
with the outlet box (must support 35
lbs). Before attaching fan to outlet box,
ensure the outlet box is securely fastened
by at least two points to a structural
ceiling member (a loose box will cause
the fan to wobble). Remove the two outlet
box screws provided with the box,
aligning the holes of the mounting
bracket with the holes of the outlet box.
Reinstall the 2 outlet box screws
securely.
6
Partially loosen downrod set screws from
yoke at top of motor assembly.
Thread lead wires and safety cable from
motor assembly through downrod.
3
Mounting bracket
Downrod
Canopy
Yoke cover
Downrod
Yoke
10/1/2014