Fault Repair; Spin Before First Water Intake Not Possible; Service; Detergent Dispenser Removal - Miele W1113 Technical Information

W1113, W1119, W1203, W1213 & W1215 Clothes Washers
3

Fault Repair

3.1

Spin before first water intake not possible

Reason
Water intake to at least level 1 has not occurred.
Warning!
Spinning is only possible after the first water intake to at least level
1 has taken place. Blocking the spin function prevents a spin from
being carried out with the transport struts in place. Usually the first
water intake occurs only after the entire appliance has been
installed including the removal of the transport struts.
Refer to the Miele Installation Manual for further details on
installation procedures.
4

Service

4.1 Detergent Dispenser - Removal
1. Remove the Dispenser Drawer.
2. Disconnect the electrical connections from the Water Path
Control System.
3. Disconnect the Non-Return Valve and Suds Container Vent
Hoses from the Dispenser Assembly.
4. Disconnect the Concertina Hose from the Dispenser Assembly.
5. Remove the two retaining screws.
6. Pull the Dispenser Assembly toward the rear of the appliance,
lift it upward to remove it from the appliance.
27
Technical Information