SMART forfour Owner's Manual page 160

Displays and operation
158
eco score display (
F
Reserve fuel display (
b Brake lamp failure warning lamp
G
Y
( page 168)
Total distance recorder
H
V Cruise control (
I
È Limiter
Menus and multi-displays
Overview
The arrangement of the menus and displays
can be envisaged as a circle.
X
To scroll: repeatedly press the ´ but-
ton on the multifunction lever.
The menu functions/displays are shown
one after the other.
i If the ´ button is pressed and held
for approximately 3 seconds, the trip
meter appears directly on the display.
Depending on the vehicle equipment, you
can call up the following menus/displays
one after the other:
display and reset the trip meter
R
Y
( page 158)
display the current fuel consumption
R
Y
( page 158)
display the service due date
R
Y
( page 218)
set the time menu (
R
restart the tyre pressure monitor
R
Y
( page 254)
Resetting values
You can reset the trip meter data and the
eco score display (
reset the eco score if the display is show-
ing the current fuel consumption.
X
Repeatedly press the ´ button on the
multifunction lever until the display
Y
page 140)
Y
page 155)
Y
page 145)
Y
page 158)
Y
page 140). You can only
shows the trip meter data or the current
fuel consumption.
X
Press and hold the b button on the
multifunction lever.
The trip meter value or the eco score
display flashes for approx. 3 seconds.
The data is then reset.
The count in the eco score display only
reappears once a distance of approx.
400 m has been covered. If the ignition
remains switched off for longer than four
hours, the eco score display in the on-
board computer will be automatically
reset.
X
When the value has been reset, release
the b button.
If you release the b button earlier,
the data shown will not change.
Current fuel consumption
When the vehicle is stationary or up to a
speed of approximately 5 km/h, the display
shows the current fuel consumption as a
numeric value in l/h.
Setting the time
X
Repeatedly press the ´ button on the
multifunction lever until the display
shows the ° symbol alongside the
time.
X
Press and hold the b button on the
multifunction lever until the hour value
flashes.
X
Press ´ to set the hour and confirm
the selection with b.
The minute value flashes.
X
Press ´ to set the minutes and b to
confirm the selection.
The display will show the time selected.
i If the ´ button on the multifunction
lever is pressed and held when setting
the time, the numerical values will
change continuously.