Panel Tuning Mode; Model Set Mode; Clone Mode - HYT TM-628H Service Manual

Panel Tuning Mode

You can perform tuning in the following steps:
1) Power on the radio while holding down P1 to enter the tuning mode.
2) Use ▲/▼ to select the tuning item, and press P4 to enter.
3) After you enter the sub-item by pressing P4, use ▲/▼ to adjust the parameter, and press P4 to save
and enter the next sub-item; or press P1 to return to the previous menu without saving the settings.
Tuning items and display (***: 1-256): Please go to Tuning Description---Panel Tuning Mode---Tuning
items and Display for details.

Model Set Mode

You can go with operations in this mode as follows:
1) Power on the radio while holding down P2 to enter the Model Set mode. At this time, the LCD displays
"DESTINA.*", where "*" represents the model number.
2) Use ▲/▼ to select the model number 0-5.
3) Press P4 to confirm your selected model number. The LED glows orange and the LCD displays
"WAIT". After reset, the radio enters User mode.
Note: Once a new model is set by pressing P4, the previously stored channel information (such as
frequency, CTCSS/CDCSS and functions assigned to each channel) will be cleared, and some
functions will also be changed. Therefore, do not perform this operation unless it's very
necessary (e.g. when EEPROM is replaced).

Clone Mode

Data can be transferred from radio to radio either by wired cloning or wireless cloning. Operation
methods are given in the following paragraphs.
Wired Clone Mode
1) Power on the source radio while holding down P3. The radio displays "CLONE" and enters Clone
mode or enters User Mode if Clone Mode is set OFF by your dealer.
2) Press P3 to switch between Dealer Clone Mode and Factory Clone Mode, with "DEACLONE" and
"FACCLONE" displayed respectively. The radio restores its original display mode in 5 seconds.
Dealer Clone Mode is the default mode in which tuning data and embedded messages will not be
cloned. However, in Factory Clone Mode, all data will be cloned.
3) Connect two radios using a clone cable, and then turn on the target radio.
TM-628H Service Manual
8