Mitsubishi Electric PLK - G Series Technical Manual page 36

(9)Setting table / Step file setting
►For Setting table/ step file setting, press
If setting is not necessary, goto (10).
►Choose one of following buttons.
Reads Setting table and Step file
Reads Setting table only
Reads Step file only
Reads System file ,Setting table and Step file
►Connect USB memory
to the connector on the front panel of the control box, then,
press .
►After file name selection screen is displayed, choose target
filename by using up and down arrow button, then press
. Goto (12)
[*1] Setting table and Step file must be saved in the
[ ] folder in the USB memory.
(10) Model / Language setting screen is displayed again.
► press
.
[*1] , which above data is contained,
.
[10] - 6