Mitsubishi Electric PLK - G Series Technical Manual page 24

Electronic pattern sewing machine
Table of Contents

Advertisement

2.Outline of customized input/output mode
(A to E below correspond to A to E on the previous page.)
(1)Customizing the input signal
The ON/OFF signal input from the input port passes through the input control section (no operation,
A.
alternate operation, signal reversal), and is then stored in the physical input area corresponding to the
input port.
(Refer to page[8]-3)
Each signal stored in the physical input area is connected to a desired position in the sewing machine
B.
control virtual input port.
C.The sewing machine carries out control based on the function assigned to the virtual input area.
(2)Customizing the output signal
As opposed to the customized input, the virtual output area port, assigned a specific meaning, can be
D.
connected and set to a desired position in the physical output area port.
The signal for each port in the physical output area passes through the output control section
E.
(no operation, delay circuit, alternate, etc.), and is then output to the output port.
3.Customizing the virtual input/output
Input control
section
Selection and connection of physical input/output port and virtual input/output port
For example, to connect the physical input port [I1] and virtual input port [SRT] (start) and to connect the
physical output port [O1] and virtual output port [T] as shown in the diagram, set as follows.
1. Using customized input, select the [I1] input functions, and set SRT.
2. Using customized output, select the [O1] input functions, and set SRT.
With the above settings, [I1] and [SRT], and [O1] and [T] will be connected.
One port from the virtual input ports can be selected for the [I*] port by changing the setting.
One port from the virtual output ports can be selected for the [O*] port by changing the setting.
(Refer to page[8]-2)
Customized
input
Physical
Virtual
input
input
I1
SRT
I2
F
I3
I4
Customized
output
Virtual
output
T
L
FU
[8] - 2
(Refer to page[8]-2)
(Refer to page[8]-3)
Output control
section
Physical
output
O1
O2
O3
O4

Advertisement

Table of Contents
loading

Table of Contents