Installing The Hyper-V Server 2012 R2 Operating System - Lenovo ThinkServer TD350 Operating System Installation Manual

2. If the message Press any key to boot from CD or DVD is displayed, press any key. If the message Windows
Setup [EMS Enabled] is displayed, press Enter. Wait several minutes for the system to load the files.
3. When the Microsoft Hyper-V Server 2012 window is displayed, configure the language and other
options as you need and then click Next.
4. Click Install now.
5. Read the license terms and select I accept the license terms. Then, click Next.
6. Select the type of installation as you need. The following steps are based on the scenario that Custom:
Install the newer version of Hyper-V Server only (Advanced) is selected in this step.
7. Do one of the following:
• If the server configuration is set as RAID, do the following:
a. In the Where do you want to install Windows? window, connect the USB storage device that
contains the driver to your server and then click Load Driver.
b. When the Load Driver window is displayed, click Browse to go to the folder where the driver
is stored.
c. Click OK. The Select the driver to be installed window is displayed.
d. Select Hide drivers that aren't compatible with the hardware on this computer, and then
select the driver that you want to install on your server. Click Next.
• If the server configuration is set as IDE or AHCI, go to next step.
Note: If the server configuration is set as AHCI, ensure that you install AHCI drivers after operating
system installation. See "Installing the driver for the SATA AHCI" on page 43.
8. In the Where do you want to install Windows? window, click Drive options (advanced).
9. Select the hard disk drive on which you want to install the operating system, and then click New.
10. Type the amount of space (in MB), and then click Apply. Click OK if prompted.
11. Select the drive partition on which you want to install the operating system, and then click Next. The
installation begins.
Note: Your server restarts several times during the installation.
12. If the Press Ctrl+Alt+Delete to sign in window is displayed, press Ctrl+Alt+Delete. If the Microsoft
Hyper-V Server 2012 window is displayed, click Administrator.
13. Follow the instructions on the screen to change the password and then log in to the operating system.
Note: The password must be a combination of upper case letters, lower case letters, and numbers.

Installing the Hyper-V Server 2012 R2 operating system

To install the Hyper-V Server 2012 R2 operating system, do the following:
1. Insert the operating system installation disc into the optical drive that you have set as the first startup
device. Then, start the server from the optical drive.
2. If the message Press any key to boot from CD or DVD is displayed, press any key. If the message Windows
Setup [EMS Enabled] is displayed, press Enter. Wait several minutes for the system to load the files.
3. When the Microsoft Hyper-V Server 2012 R2 window is displayed, configure the language and other
options as you need and then click Next.
4. Click Install now.
5. Read the license terms and select I accept the license terms. Then, click Next.
6. Select the type of installation as you need. The following steps are based on the scenario that Custom:
Install the newer version of Hyper-V Server only (Advanced) is selected in this step.
.
Chapter 2 Installing an operating system in legacy mode
19