Operation - Pro-Max CG5SSPT-120V Installation And Operation Instructions Manual

PROGRAMMING
This unit has separate control boards for the left and right cooking surfaces, because of this the
program time & temperature, must be done for each side.
To Program Time and Temperature:
1. Press and hold "TEMP" (actual temperature displays).
. While holding "TEMP," press and hold any program button on the related side for one
second, the LED above the program number light and the display reads "_ _ _ _." Enter
the four-digit security code sequence, 4, 3, 2, 1. The security code will not show on the
display. Once the correct sequence has been entered, the preset time will be displayed
and the LED for that program will begin to flash.
. Set the time with the "+ or -" buttons.
. Press the "TEMP" button to save the time.
5. The preset temperature for the bottom will be displayed.
. Set the desired temperature for this program using the "+ or -" buttons.
7. Press the "TEMP" button to save the bottom temperature.
8. The preset temperature for the top will be displayed.
9. Set the desired temperature for this program using the "+" or "-" buttons.
10. Press the "TEMP" button to save temperature and to exit programming mode for this
program. The LED will stop flashing but will remain lit.
11. Press any other program button within 15 seconds to continue programming without
re-entering the security code.
12. While programming a program (LED is flashing), if no input is received for 15 seconds,
the unit will revert to normal operation and the security code must be re-entered.
Note: Time and temperature settings are done with both sides individually. If changes
are made to the left side, similar changes may have to be made to the right side. Each
programming change must be saved by pressing the "TEMP" button.

OPERATION

1. Pressing any program button (1-4) will start the timer countdown and display the preset
time remaining. The LED for the appropriate program will be lit during countdown
and remain lit until another program is selected.
2. When the display reaches "00:00", the buzzer will sound and the digits will flash.
3. Press the program button to silence the buzzer and return the readout to programmed
time.
. The right and left sides will operate independently of each other. Both timers can be in
operation at the same time. The "00:00" display will show which side is timed out.