ELECTRICAL CONNECTIONS
ELECTRICAL CONNECTIONS (Cord Connected Mixers)
Single-Phase Mixer
The electrical cord on this machine is equipped with a three-pronged grounding
plug which must be connected to a properly grounded receptacle. If the receptacle is not the proper
grounding type, contact an electrician. Do not remove the grounding prong from the plug.
ELECTRICAL CONNECTIONS (Non-Cord Connected Mixers)
Electrical and grounding connections must comply with the applicable
portion of the National Electrical Code and/or other Local Electrical Codes.
Disconnect the electrical power to the machine and follow lockout/tagout
procedures.
Three-Phase Mixer
A hole for the 3/4 "-trade-size conduit is located in the rear of the pedestal. Make electrical connections per
the wiring diagram located on the inside of the top cover.
•
Remove side cover.
•
Connect fi eld supply lead wires L1, L2, and L3 to supply harness wires labeled "SERVL1",
"SERVL2", and "SERVL3" respectively.
•
Connect ground wire to supply harness green wire.
•
Reinstall side cover.
FMS30 & FMS40 Owner/Operator Manual
– 4 –