Installation, Operation, and Care of BERKEL FMS30 & FMS40 Quart MIXER SAVE THESE INSTRUCTIONS GENERAL The 30 quart mixer has an AC Induction electric motor and motor control. A 30 quart bowl, B-Flat beater, spiral dough hook, D wire whip and ingredient chute are shipped as standard equipment. A 0 - 15 minute timer and four plastic foot pads are standard.
ELECTRICAL CONNECTIONS ELECTRICAL CONNECTIONS (CORD CONNECTED MIXERS) Single-Phase Mixer The electrical cord on this machine is equipped with a three-pronged grounding plug which must be connected to a properly grounded receptacle. If the receptacle is not the proper grounding type, contact an electrician. Do not remove the grounding prong from the plug.
OPERATION Moving beater in bowl. Keep hands, clothing, and utensils out while in operation. Do not use without interlocked guard. Controls Attachment Hub Thumb Screw and Plug Bowl Guard/ Splash Guard Bowl Guard/ Wire Cage Bowl Lift Handle Agitator Bowl Support Fig.
CONTROLS (FIG. 2) Speed Selector Starts Mixer Time Selector Stops Mixer Fig. 2 Push-button Start and Stop buttons control power to the mixer. The Bowl Guard /wire cage must be in place and closed or the mixer will not operate. If the Bowl Support is not all the way up, the mixer will not operate.
MIXING This section explains operation of the mixer and how to install bowls and agitators. BOWL New mixer bowls and agitators (beaters, whips, spiral dough hook, ingredi- ent chute and splash cover) should be thoroughly washed with hot water and a mild soap solution, rinsed with either a mild soda or vinegar solution, and Fig.
BOWL GUARD / WIRE CAGE Wire cage must be in position and closed in order to mix. If wire cage is opened during the mixing, mixer will stop. REMOVE BOWL GUARD / WIRE CAGE Lower the bowl support and remove agitator before removing bowl guard/wire cage. Hold wire cage with both hands and pull downward gently to release from retainer (Fig.
MIXING BOWL CAPACITY CHART Capacity of Bowl (Qts. Liquid) 30 Quart 40 Quart Agitators Model FMS30 FMS40 Suitable for Motor (HP) Operation Overall Space Required (Bench Space) 21 ½" W X 26¼" D 21 ½" W X 26 ¼"D X 45"H X 48"...
AGITATORS AND ACCESSORIES B Flat Beater D Wire Whip Spiral Dough Hook Ingredient Chute Splash Cover MAINTENANCE Disconnect electrical power before beginning any maintenance procedure. MOTOR The motor has sealed ball bearings which require no lubrication maintenance. BOWL LIFT SLIDEWAYS The bowl lift slideways (Fig.
To obtain service and parts information concerning the FMS30 & FMS40, you have two options: You can contact the local Designated Berkel Service Location (DBSL). To locate the nearest DBSL, please visit www.berkel.com. Additional information may be obtained by dialing (800- 348-0251).
Berkel's obligation and liability under this warranty is expressly limited to repairing or replacing equipment that proves to be defective in material or workmanship within the applicable warranty period. Berkel or a Designated Berkel Service Location will perform all repairs pursuant to this warranty. Berkel expressly excludes responsibility for incidental or consequential damages to buyer or any third party, including, without limitation, damages arising from personal injuries, lost profi...