Hotpoint RB740G Use And Care & Installation page 26

Hide thumbs Also See for RB740G:
Table of Contents

Advertisement

Care and Cleaning
operating the self-cleaning oven
Set the Oven for Cleaning
The range must be completely cool
in order to set the self-clean cycle.
1. Slide the latch handle to the right
as far as it will go. You may need to
press slightly on the door to get it
to lock properly.
Never force the door latch handle.
Forcing the handle may damage
the door lock mechanism.
2. Push the CLEAN button.
The display will show "3:30?'
The words "CLEAN TIME" will
be displayed on the left. Within 20
minutes, the words "CLEAN
LOCK" will be displayed on the
right.
find out when the
Note: You can
clean cycle will be finished by
pushing the
The word "DOOR" is displayed
when you try to set a clean cycle
with the door unlatched or when
the oven temperature is too high.
26
(continued)
To Set a Delayed Stirt
1. Slide the latch handle to the right
as far as it will go.
2. Push the S~P TIME button.
3. Turn the SET knob to time of day
when you wish cleaning to be
completed (must be more than 31/2
hours later than current time
of day).
4. Push the CLEAN button.
The words "DELAY CLEAN"
clean cycle starts. After the clean
cycle starts, the word "CLEAN"
will be on in the display.
Note: During a delayed self-clean
operation, you can find out when
the oven turns on by pushing and
holding the CLEAN button.
To Stop a Clean Cycle
1. Press the CANCEL button.
2. Wait until the oven has cooled
below locking temperature (about
20-30 minutes) and the word
"LOCK" is off in the display.
3. Slide the latch handle to the left
as far as it will go.
You will not be able to open the
door right away unless the oven
temperature is at a safe level. If
you cannot open the oven door
immediately afier the word "LOCK"
goes off, wait about one minute and
try again.
After Self-Cleaning
1. When a clean cycle is finished,
the word "CLEAN" will be off in
the display.
2. Wait until the oven has cooled
below locking temperature (about
20-30 minutes) and the word
"LOCK" is off in the display.
3. Slide the latch handle to the left
as far as it will go.
You will not be able to open the oven
door unless the oven temperature
is at a safe level. If you cannot open
the oven door immediately afier the
word "LOCK" goes off, wait about
one minute and try again.
You may notice some white ash
in the oven. Just wipe it up with
a damp cloth.
If white spots remain, remove them
with a soap-filled steel wool pad.
Be sure to rinse thoroughly with a
vinegar and water mixture. These
deposits are usually a salt residue
that cannot be removed by the
clean cycle.
If the oven is not clean after one
clean cycle, repeat the cycle.

Advertisement

Table of Contents
loading

Table of Contents