Positioning The Appliance; Water Outlet - Omega PL402XA Instruction Manual

Positioning the Appliance

Position the applianc e in the desired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets o r wa lls. T he dishwasher is equipped with water supply and drain hoses th at can
be positioned either to the righ t or the left sides to facilitate proper installation.
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the excess water in hoses cann ot be drained dire ctly
into the sink. It will be necessary to drain excess water from hoses into a bo wl o r suitable
container that is held outside and lower th an the sink.

Water Outlet

Connect the water drain hose. The drain hose mu st be correctly fitted to avoid water leaks.
Ensure that the water dra in hose is no t kin ked or squashed.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced .
Syphon Connection
The waste connection must be at a he ight of between 40 cm (minimum) and 100 cm (ma ximum)
from the bottom of the dish. T he water drain ho se should b e fixed by a hose clip. The free end of
the hose must not be immersed in water.
The following things should be checked before starting the dishwasher.
1
The dishwasher is level and fixed properly
2
The inlet valve is open
3
There is a leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
The inlet and drain hoses are knotted
7
All packing materials and printings should be taken out from the dishwasher
After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users.
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time , let the
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water in let to be blocked and damage the a ppliance.
Th e water supply to the applianc e can also be connected to the house hold hot water
line (such as, central system, heating system),as long as it does not exceed a
temperature of 60 C. In this case, the wash cycle time will be shortene d by about 15
minute s and the wash efficiency slightly reduced .
Th e co nnection must be made to the hot water line following the same procedures as
described in the sec tion for the c onnection to the cold water line.
In or der to avoid that there is more water staying in the inlet hose, please close
the hydrant after using.(Not applicable to appliances without aqua-stop.)
21