Omega PL402XA Instruction Manual page 23

Dishwasher must be level for proper dish rack operation and wash performance.
1
Place level on door and rack track inside the tub as shown to check that the
dishwasher is level.
2
level the dishwasher by adjusting the four leveling legs individually.
3
When level the dishwasher, please pay attention not to let the dishwasher tip over.
【
Figure 8
Illustration of feet adjustment
NOTE:
The maximum adjustment
height of the feet is 60 mm.
WARNING!
Plea se look at the ra ting label to know the rating voltage and connect the dishwash er to the app ropriate power supp ly.
Use the required fuse 10 amp, time delay fuse or circuit breaker rec ommended and provide separate circuit serving
only this appliance.
This appliance must be earthed. In the event
of a malfunc tion or breakdown, earthing will
reduce the risk of electric shock by providing a
path of least resistance for the electric current.
This app liance is equipped with a cord ha ving an
equipment-earth ing conductor and an earthing
plug . The plug must be p lugged into an ap propriate
outlet that is installed and earthe d in acco rdance
with all local standards a nd requirements.
】
Check lever
fro nt to back
For personal safety:
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE EARTHING
CONNECTION FROM THE POWER CORD.
Ensure the voltage and frequen cy of the power being corresponds to
those on the rating plate. Only insert the plug into an electrical socket
which is earthed properly. If the electrical socket to which the appliance
must be connected is not appropriate for the plug , replace the sock et,
rather than using a adaptors or the like as th ey could cause overheating and burns.
Check lever side to side
Improper connecti on of th e equ ipment-
grounding conductor ca n re sul t i n th e risk
of an electric shock. Che ck wi th a qualified
electrici an or service represe ntativ e if you
are i n doubt whether the app li an ce is
properly grounded. Do no t modify the plug
p rovided with the appliance; If it is n ot fit
for the out let. Have a pro per outl et install ed
by a qualified electrician.