Mask Fit; More Options; Caring For Your Device - ResMed AirCurve 10 User Manual

If you continue to get a dry nose or mouth, or moisture in your mask, consider using ClimateLineAir
heated air tubing. ClimateLineAir together with Climate Control delivers more comfortable therapy.

Mask Fit

Mask Fit is designed to help you assess and identify possible air leaks around your mask.
To stop Mask Fit, press the dial or Start/Stop. If you are unable to get a good mask seal, talk to your
care provider.

More options

Your care provider may have given you access to personalise a few more options.
Leak Alert
SmartStart
Mask
Run Warmup

Caring for your device

It is important that you regularly clean your AirCurve 10 device to make sure you receive optimal
therapy. The following sections will help you with disassembling, cleaning, checking and
reassembling your device.
To check Mask Fit:
1. Fit the mask as described in the mask user guide.
2. In My Options, turn the dial to highlight Run Mask Fit and then press the
dial.
The device starts blowing air.
3. Adjust the mask, mask cushion and headgear until you get a Good result.
When Leak Alert is enabled, the device beeps if the mask leaks too much air
or if you remove the mask during therapy.
When SmartStart is enabled, therapy starts automatically when you breathe
into your mask. When you remove your mask, it stops automatically after few
seconds.
This option shows your mask type setting. If you use more than one type of
mask, adjust this setting when switching between masks.
This option allows you to pre-heat the water before starting therapy, so that
the air is not cold or dry at the beginning of therapy.
To adjust the Humidity Level:
1. In My Options, turn the dial to highlight Humidity
Level and then press the dial.
2. Turn the dial to adjust the humidity level and press
the dial to save the change.
English 7