Maytag MTF2455DRB User's guide Manual page 5

Tools Required: Phillips screwdriver,
5/16" socket and ratchet, putty knife or
5/16" end wrench.
1. Remove the hinge cap and set aside.
2. Remove screws and hinge with a
5/16" socket wrench and set aside.
10.
11.
12.
3. Carefully lift and remove freezer door.
4. Remove screw and hinge arm from 13.
top of the refrigerator door.
5. Carefully lift and remove refrigerator 14.
door.
6. Remove grille cover and set aside. 15.
7. Remove hinge plate from lower cor-
ner of refrigerator and secure it on the
opposite side.
8. Remove the plate from the underside
of the refrigerator door and secure it
on the opposite side.
9. Remove the plate from the underside
of the freezer door and secure it on
the opposite side.
÷
Remove the plug buttons from tops of
freezer and refrigerator doors and
replace them on the opposite side.
Remove screw hole plugs from top of
cabinet and replace on the opposite
side.
Remove washers and stem from the
inside of the hinge plate and place
them on the outside of the hinge
plate.
Carefully replace refrigerator door on
the hinge plate in lower corner.
Slide the hinge arm into place and
secure with screw.
16.
Carefully place freezer door on top of
hinge arm use foam door spacer to
set gap.*
Slide top hinge into place on freezer
door and secure screws with 5/16"
wrench.
17. Snap hinge cap securely in place.
18. Replace grille cover.
Remember to plug in your refrigerator
and reset the controls to the appropriate
setting(s).
(IF NEEDED)
Rest door on a non-scratching surface.
Toolsj
A. Remove left screw.
B. Open door and lift. Rest door on a
non-scratching surface.
J
Remove hinge plate assembly. Rest door
on a non-scratching surface.
Do not discard the foam door spacer.
Doors may settle with use.