Replacing A Memory Module; Removing The Diskette Drive; Retainer Bracket For Diskette Drive - Lenovo ThinkCentre 7061 Hardware Installation And Replacement Manual

This section provides instructions on how to replace the diskette drive.
1. Remove the computer cover. See "Removing the cover" on page 11.
2. Remove the front bezel. See "Removing and replacing the front bezel" on page
3. Disconnect the signal and power cables from the rear of the diskette drive.
4. Press the release button and slide the diskette drive out the front of the
Figure 29. Removing the diskette drive
5. Remove the retainer bracket from the failing diskette drive and install it on the
Figure 30. Retainer bracket for diskette drive
6. Slide the new diskette drive into the drive bay until it snaps into position.
7. Connect the flat cable to the new diskette drive.
8. Replace the front bezel.
9. Go to Chapter 4, "Completing the parts replacement," on page 45.

Replacing a memory module

12.
computer.
new diskette drive.
Attention
Do not open your computer or attempt any repair before reading the "Important safety
information" in the Safety and Warranty Guide that was included with your computer. To
obtain a copy of the Safety and Warranty Guide, go to the Support Web site at
http://www.lenovo.com/support.
Chapter 3. Installing options and replacing hardware
33