Chapter 4. Completing The Parts Replacement; Replacing The Computer Cover; Lenovo 2005, 2008. Portions © Ibm Corp - Lenovo ThinkCentre 7061 Hardware Installation And Replacement Manual

Chapter 4. Completing the parts replacement

After completing all parts replacements, you need to close the cover and reconnect
cables, including telephone lines and power cords. Also, depending on the part
that was replaced, you might need to confirm the updated information in the
Setup Utility program. Refer to "Using the Setup Utility" in the User Guide for this
product.
To replace the computer cover and connect cables to your computer:
1. Ensure that all components have been reassembled correctly and that no tools
2. Position the computer cover on the chassis so that the rail guides on the bottom
Figure 43. Replacing the computer cover
3. If the cover is secured with thumbscrews, install them.
4. If a cover lock is installed, lock the cover.
5. Reconnect the external cables and power cords to the computer. See "Locating
© Lenovo 2005, 2008. Portions © IBM Corp. 2005.
or loose screws are left inside your computer. See "Locating components" on
page 8 for the location of various components.
of the computer cover engage the rails. Then, push the computer cover closed
until it snaps into position.
connectors on the rear of your computer" on page 6.
45