Error Code And Significance - Orbit SS 255 Owner's Manual

Error code and significance

Fault Code
Communication abnormal: The
control and computer has
abnormal communication after
start
E1
No Speed Wireless Sensor
Network: Can't receive the
motor speed sensor feedback
above three seconds.
E2
The motor wire is not
connecting well
Current overload Protection ,
the motor electrical is overload
E3
E4 Incline self-learning fault
Incline sensor error
E5
Explosion-Proof Protection：
Some unusual condition of
power or voltage that cause
damage to the motor drive
circuit.
E6
The upper EEPROM is
E7
recorded faulty
The lower EEPROM is
E8
recorded faulty
23
Fault Description
The controller is not working and going into fault. The machine can
not run, the computer shows fault code "E1", and the buzzle will
ring three times.
Possible Reasons: Communication obstructed between controller
and computer, please check the wire and make sure the wire
connect well and the wire without any damager..
Stop and go into fault status, computer buzzle will ring 3 tones and
shows fault code"E2". Other areas show blank. After 10 seconds
will go into ready mode, and can restart.
Possible Reasons：Can't receive the motor speed sensor
feedback above three seconds, please check sensor plug and
motor connect wire and the controller.
Stop and go into fault status, computer buzzle will ring 3 tones
and shows fault code"E3". Other areas show blank. After 10
seconds will go into ready mode, and can restart.
Possible Reasons：Check if the motor wire is connected well and
re-connect the motor wire well if not; check if the controller has the
smell and change the controller if have
Stop and go into fault status, computer buzzle will ring 3 tones
and shows fault code"E3". Other areas show blank. After 10
seconds will go into ready mode, and can restart.
Possible Reasons：Over the rated load cause too much electricity
that make system Self-preservation or some parts blocked and
make DC motor can't process. Adjust the machine and restart.
Another please check the DC motor or controller have any burned
smell or not. If yes, please change the motor or controller. Another
make sure the power and voltage is comply with standard.
Check incline motor sense wire and AC wire are inserted well; AC
wire is right inserted according to the indentify in the incline
motor; make sure the incline motor wire without damager; after
check those, press the button on controller, then start self-learning
again.
Check incline motor sense wire and AC wire are inserted well; AC
wire is right inserted according to the indentify in the incline
motor; make sure the incline motor wire without damager; after
check those, press the button on controller, then start self-learning
again.
Stop and go into fault status, computer buzzle will ring 3 tones
and shows fault code"E6". Other areas show blank. If recover then
go into ready mode, then can restart.
Possible Reasons：The power voltage is less than normal or the
controller has some problems. Make sure the motor wire is
connecting well.
Change upper EEPROM
Change lower EEPROM
Fault Processing