Blue Led; Back Panel; Power Cord; Outlets - Raritan Dominion PX User Manual

Back Panel

LED State
Not lit (Light grey)
Red
Red flashing
Green
Note: Connecting any power CIM except the for the D2CIM-PWR (such
as P2CIM-PWR) to the serial port of the Dominion PX will switch all the
outlets to the ON state, even if they were previously OFF

Blue LED

Only 1U and 2U models have a blue LED on the front panel. The blue
LED on the right side of the front panel is lit solid as soon as the
Dominion PX unit is plugged in.
The back panel of the 1U and 2U Dominion PX units consists of, from left
to right, a power cord, power outlets to connect devices to the Dominion
PX, and a display panel; the Zero U models do not have a back panel.

Power Cord

The power cord that connects the Dominion PX to a power source is
located on the far left of the back panel or on the end of the unit if the
unit is a Zero U type. No devices can be rewired by the user.
Note: Each Dominion PX model should be plugged into an appropriately
rated outlet for its type.
There is no power switch on the Dominion PX. On products rated at over
20A there are branch circuit breakers that are fully shrouded to prevent
accidental operation. To power cycle the unit, remove the power cord
from the power source and then re-connect it.

Outlets

The number of outlets on the back panel depends upon the Dominion PX
model. To the upper left of each outlet is a small LED. The units are
shipped from the factory with all outlets powered ON. The table below
explains how to interpret the different LED states.
Outlet Status
Unit OFF
ON and LIVE
ON and LIVE
OFF and LIVE
Chapter 4: Using the Dominion PX
What it Means
The outlet is not connected to power or the control
circuitry's power supply is broken.
The outlet is ON (relay closed) and LIVE (voltage
present).
The outlet is ON and LIVE, but there is overload
and the current has crossed the non-critical
threshold.
The outlet is OFF (relay open) and LIVE.
21